Calix Community  
 
Reply
Highlighted
Calix Certified
Posts: 15
Registered: ‎12-05-2012
0

Tagged and Untagged traffic on a AE ONT trunk port

I have a 717ge deployed with a trunked eth port, this ONT is connected to an E7 GE interface. There are 2 vlans on the trunk (200, 210) I need the ONT to remove the 200 tag when it leaves the ONT port and I need 210 to remain tagged when it leaves the ONT port and the inverse operation to take place for the upstream traffic into the ONT. We currently do not use CMS to provision AE ONTs and for any non-standard configs we make changes at the CLI level. I was playing around with the lev2 and bridge setting in the CLI but I have not had much success. I have been referencing AE_ONT_R31_CLI.pdf are there any other materials that might point me in the right direction?

Calix Certified
Posts: 1,867
Registered: ‎03-11-2010
0

Re: Tagged and Untagged traffic on a AE ONT trunk port

@wadeh I don't have the answer to your question, but I do have one question that may be important: When you strip 200 off, does that reveal some C-tags and untagged traffic, or is it only untagged?

if it's the second, it's possible a rule could be written to push tag 200 on top of any ingressing untagged traffic.

Moderator
Posts: 356
Registered: ‎06-24-2014
0

Re: Tagged and Untagged traffic on a AE ONT trunk port

@wadeh I spun up what you are detailing here in CMS and snagged the config it generated, here's the pertinent piece:

bridge setup -mf=enable -snoop=disable -onlydhcp=enable -onlymacff=enable -onlysv=enable -dcir=10000000 -dpir=10000000 -ucir=10000000 -upir=10000000 -attach=vlan -mshaper=0 vid=200 dev=eth-0
bridge setup -mf=enable -snoop=disable -onlydhcp=enable -onlymacff=enable -onlysv=enable -dcir=10000000 -dpir=10000000 -ucir=10000000 -upir=10000000 -attach=vlan -mshaper=0 vid=210 dev=eth-0
lev2l2tag add -treatinpri=0 -treatinvid=200 dev=eth-0
lev2l2tag add -treatinpri=0 -treatinvid=210 -filtinvid=210 dev=eth-0


This would do the following:
Upstream traffic ingressing the GE port
Untagged - > add tag of 200
Tagged 210 > change tag to 210

Downstream traffic egressing the GE port
Tag of 200 > stripped > untagged
Tag of 210 > Change to 210

This should accomplish what you're looking for assuming you're receiving untagged traffic for your vlan 200 service.
Calix Certified
Posts: 15
Registered: ‎12-05-2012
0

Re: Tagged and Untagged traffic on a AE ONT trunk port

Thank you for the config portion, I am going to set this up and test it in the lab.